Divesuits at Robin Hood Watersports

Established 1981- UK's largest stock - Advice from experience

Robin Hood Watersports
152 Leeds Road
Heckmondwike
WF16 9BJ
Tel: 01924 444888
Fax: 01924 474529
Email:sales@roho.co.uk

While Robin Hood Watersports uses reasonable endeavours to ensure the accuracy of information on the site, to the extent permissible by law, it expressly excludes all liability including liability for any representation (unless fraudulent) and cannot accept any liability for the accuracy or content of any other websites with links into or out from the site. Any advice or recommendation given is followed or acted upon entirely at your own risk.

			You will need the following equipment: scissors valves aquafix/aquasure glue.
			Unscrew the valve so that you have all three pieces as shown: top part of valve washer back part of valve.
			Position the washer where the valve is to be fitted and draw round the inside of the washer.
			Cut out the hole that you marked.
			Clean the components with thinners and apply glue to the face of the valve. Be careful to avoid getting any glue on the thread of the valve.
			Push the valve through the hole in the suit so that the glued face sticks to the outside of the drysuit. On the inside of the valve, make sure that the fabric does not go up the thread. Put the washer on the valve and firmly screw the valve back together.
			The valve is now fitted in the required place.